Well, my project has progressed I have come across two minor dilemmas in my binding project. I finally have all of my issues organized, mapped, and ads removed but I am left with a few nagging questions about how proceed next. Since I am using my local bindery, I am trying to decide whether I should go ahead and pre-cut all of my books so I have single pages. Some of the issues I have collected had odd stapling and ended up a bit crooked. I figure I might be able to prevent excess cutter loss and loss from trim by prepping my book in advance. I am debating whether I should obtain a nice paper cutter or stay with the tried and true Exacto and ruler method that has kept me in good shape so far. The next issue that I am having is that all of my attempts at scanning and printing are not quite turning out right. I have jpegs of all the pages that I want to use from the History of the Multiverse and History of the DC Universe from the back-up pages, but I am not able to get them line-up when I print double sided. I have tried adding a border to try and accommodate for this and used various tips and tricks found, but I could really use a pros hand here. I am not even sure I have my image size lined up properly for the whole process in order to not lose too much with trim, gutter, and all that other jazz. Any advice would be greatly appreciated.